How to reset & enter the INITIAL-SETUP mode on CAL Controllers

To enter into the INITIAL-SET-UP mode in a CAL 3200/3300/9300/9400/9500 you have to reset your unit.

** We strongly recommend that you create a record of all current parameters before resetting, because this sets them all at their default values **.

To reset, first go the Rset parameter in Level 3 and change its value to "ALL".
Press UP and DOWN buttons together for 3 seconds.
The reset is perfomed and inPt is shown in the display
Hold down the * button and use the UP or DOWN buttons to set the correct input type. Do the same for the Units and SP1.d output selection.

You can now exit back to level 1 to complete the other configuration settings.